MotoRack is easily installed with four bolts and will fit a mini to full size truck bed.

1

Using right and left ends of MotoRack, place in respective corner of truck bed. Mark on lip of truck bed drill holes. Using a 3/8 inch drill bit, drill through lip of truck bed. Do both right and left side. Loosely bolt the left and right ends to lip of truck bed.

2

Place wheel block on left end, place middle bar into left wheel block, place right wheel block onto right end and then slide over center bar. This should make one continuous piece.

3

Tighten left and right ends. Adjust wheel blocks to desired location, then tighten 4 bolts on each wheel block.